Using Receiver Config - From V1.1
File
Properties
Menu:
Load the program on your PC – it will try to find an existing Eltek folder. To program the
RC250 use the LC68 lead. Connect one end to the serial port of the PC and the other to
the mini DIN socket situated on the top panel of the RC250. Set the Com port using
>
.
File
Load Receiver Upload an existing RC250 configuration
File
Save Receiver Save the current RC250 configuration
File
Properties
Select PC serial port for communications with RC250 and
Transmitter
Tools
Turn Receiver
off
Turns receiver off (display indicated OFF)
Tools
ModBus
Setup
Sets device (node) address and register addresses for
ModBus communications. See ModBus Configuration
section.
Buttons:
Get TX
Get the current configuration from the Transmitter
Set Interval
Set TX Interval (use the drop down menu)
Set Sensor On
Time
Applicable only to transmitter where the external sensor
needs power before a reading can be taken. E.g.
GS42/GS44 and GD43
Get RX
Get the current configuration from the RC250
Set RX
Set the configuration in the RC250
Start Meter /
Stop Meter
Load table with received data
Edit Chan
Click over a channel, click Edit Channel to edit. (Use to
accept a transmitter not available for direct connection.)
Clear Chan
data
Click over a channel, click Clear Channel data
Set Nbr Chans
Enter Number of channels to display (160 maximum) and
click
to confirm (this reduces unnecessary
on screen information and speeds up the interface).
Set Nbr Chans
Page 3 of 8
