ELTA FANS CETO 250, Инструкция

Страница: 7 / 12

10. Close the terminal block flap and secure with the screw.
11. By pressing the upper and lower clips, fit the front cover back onto the fan body.
12. Switch the mains power supply on and check that the fan is working correctly.
Panel Installation—Recess Mounting (Fig. 2B)
1. Using the template supplied, mark out and cut a hole in the panel. Read the
instructions on the template sheet carefully.
2. Fig. 1B - By pushing the clip using a small screwdriver pull the front cover (1)
away from the fan body (2).
3. The fan body (2) is secured to the base frame (4) by 4 screws. Take out each
screw from the four corners (6) to dismantle and release the base frame.
4. Take out the screw that secures the terminal block flap (5) to the fan body (2).
5. Fig. 4. - For side exit installations, the spigot assembly (9) can be repositioned. To
do this, remove the spigot assembly (9) from the fan body (2). Rip off the guide
vane (8) from the fan body and reattach the spigot in a side orientation in the
desired direction.
6. Attach the ducting to the spigot (9).
7. Feed the cable through the hole in the terminal block (Fig. 3)
8. Using appropriate fixtures, screw the fan body (2) into the hole in the panel.
9. Follow instructions for
Electrical Connections and Wiring in B.
10. Close the terminal block flap and secure with the screw.
11. By pressing the upper and lower clips, fit the front cover back onto the fan body.
12. Switch the mains power supply on and check that the fan is working correctly.
Wall Installation—Surface Mounting
Using 100mm Elta Fans Wall Kit.
1. Drill a Ø115mm hole through the wall, ensuring sufficient space for the fan to be
installed.
2. Insert the wall sleeve with the wider diameter sleeve facing the room side and
cement both ends in place, flush with the wall. The wall sleeve must be angled
downwards to drain any condensation to outside.
3. To fix the outside grille, use the back plate as a template and mark the fixing holes
on the wall. Drill and plug the wall to fix the back plate securely into position.
4. Secure the outside grille onto the back plate with the screws provided, making
sure that the louvers are directed downwards.
5. Fig. 1B - By pushing the clip using a small screwdriver pull the front cover (1)
away from the fan body (2).
6. The fan body (2) is secured to the base frame (4) by 4 screws. Take out each
screw from the four corners (6) to dismantle and release the base frame.
7. Screw the base frame (4) to the wall using appropriate fixtures ensuring that the
opening for the spigot lines up correctly with the hole made when the fan body is
re-attached.
8. Take out the screw that secures the terminal block flap (5) to the fan body (2).
9. Feed the cable through the hole in the terminal block (Fig. 3).
10. Reassemble the fan body (2) to the base frame (4) and secure with 4 screws
11. Follow instructions for Electrical Connections and Wiring in B.
12. Close the terminal block flap and secure with the screw.
13. By pressing the upper and lower clips, fit the front cover back onto the fan body.
14. Switch the mains power supply on and check that the fan is working correctly