3
Installation and commissioning
Rain/Wind Sensor KNX RW
• Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
The following standards have been considered for the evaluation of the product in
terms of electro magnetic compatibility:
Transient emissions:
•
EN 60730-1:2000 Section EMV (23, 26, H23, H26) (threshold category: B)
•
EN 50090-2-2:1996-11 + A1:2002-01 (threshold category: B)
•
EN 61000-6-3:2001 (threshold category: B)
Interference resistance:
•
EN 60730-1:2000 Section EMV (23, 26, H23, H26)
•
EN 50090-2-2:1996-11 + A1:2002-01
•
EN 61000-6-1:2004
The product has been tested for the above mentioned standards by an accredited EMV
laboratory.
2. Installation and commissioning
2.1. Notes on installation
Warning, mains voltage!
National legal regulations are to be observed.
Installation, inspection, commissioning and troubleshooting of the
device must only be carried out by a competent electrician.
Disconnect all lines to be assembled, and take safety precautions against accidental
switch-on.
The device is exclusively intended for appropriate use. With each inappropriate change
or non-observance of the instructions for use, any warranty or guarantee claim will be
void.
After unpacking the device, check immediately for any mechanical damages. In case of
transport damage, this must immediately notified to the supplier.
BCU type
Own micro controller
PEI type
0
Group addresses
max. 254
Allocations
max. 255
Commmunication objects
81
Heating rain sensor
approx. 1,2 W (230 V and 24 V)
Measurement range wind
0...70 m/s
Resolution (wind)
<10% of the measured value
Accuracy (wind)
±25% at 0...15m/s, at an angle of attack of 45°,
pole mounting
