3
Installation and commissioning
Rain/Wind Sensor KNX RW
• Status: 19.08.2013 • Technical changes reserved. Errors reserved.
The product conforms with the provisions of EC guidelines
•
EMC Directive 2004/108/EC
•
Low Voltage Directive 2006/95/EC
The following standards and/or technical specifications have been applied:
•
EN 50491-5-1: 2010
•
EN 50491-5-2: 2011
2.
Installation and commissioning
2.1. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an electrician.
DANGER!
Risk to life from live voltage (mains voltage)!
There are unprotected live components within the device.
•
National legal regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
The device is only to be used for its intended purpose. Any improper modification or
failure to follow the operating instructions voids any and all warranty and guarantee
claims.
After unpacking the device, check it immediately for possible mechanical damage. If it
has been damaged in transport, inform the supplier immediately.
BCU type
Own micro controller
PEI type
0
Group addresses
max. 254
Allocations
max. 255
Commmunication objects
81
Heating rain sensor
approx. 1,2 W (230 V and 24 V)
Measurement range wind
0...70 m/s
Resolution (wind)
<10% of the measured value
Accuracy (wind)
±25% at 0...15m/s, at an angle of attack of 45°,
pole mounting
