16
Remote control programming
Remote control Remo KNX RF
• Version: 14.02.2018 • Technical changes and errors excepted.
6.
Remote control programming
Addressing of the device at the bus.
Menu: Programming mode
The equipment is delivered with bus address 15.15.250. A different address can be pro-
grammed in the ETS by overwriting the address 15.15.250. For this purpose, the program-
ming mode on the remote control must be activated.
Time point 0:
Touching the button, beginning of Time 1
Release before Time 1 runs out:
Step (or stop if the drive is moving)
Time point 1:
End of Time 1, beginning of Time 2,
Movement command
Release after Time 1 runs out
but before Time 2 is expired:
Stop
Release after Time 1+2 runs out:
Movement to the end position
Control mode
Comfort mode
Behaviour when a button is operated:
Push-button is pressed and
released before expiry of Time 1 = stop/step
held for longer than Time 1 = up or down
released between Time 1 and 1 + 2 = stop
released Time 1+2 = no more stop
Time 1 (in 0.1 sec)
0 ... 50; 4
Time 2 (in 0.1 sec)
0 ... 50
Time 1
Time 2
0
1
1 + 2
Fig. 1
Comfort mode time interval scheme
1
2
3
