4
Installation and start-up
Radio Actuator KNX RF S1R-B2 compact
• Version: 16.09.2020 • Technical changes and errors excepted.
The product is compliant with the provisions of EU guidelines.
2.
Installation and start-up
2.1. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an electrician.
DANGER!
Risk to life from live voltage (mains voltage)!
There are unprotected live components within the device.
•
VDE regulations and national regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation
is no longer guaranteed.
The device is only to be used for the intended purpose described in this manual. Any
improper modification or failure to follow the operating instructions voids any and all
warranty and guarantee claims.
After unpacking the device, check it immediately for possible mechanical damage. If it
has been damaged in transport, inform the supplier immediately.
The device may only be used as a fixed-site installation; that means only when assem-
bled and after conclusion of all installation and operational start-up tasks and only in
the surroundings designated for it.
Ambient humidity
5...80% RH, non-condensing
Operating voltage
230 V AC, 50 Hz
Maximum load
Each terminal contact may be loaded with a maximum
of 10 A.
Output
1 × output, free of potential
with 2 connections for drive up/down or 2 devices,
power supply U | up (A1) | down (A2)
Output load capacity:
5 A, maximum 270 V AC/30 V DC
Inputs
2× digital, maximum cable length 10 m
Group addresses
max. 254
Assignments
max. 254
Communication objects
86
Radio frequency
868,3 MHz (KNX RF)
