4
Installation and commissioning
Smoke alarm Salva KNX
• Version: 30.01.2017 • Technical Changes and Errors excepted.
* Please note the information on
Accuracy of temperature/humidity measurement
1.1.1. Accuracy of temperature/humidity measurement
Only for Salva KNX TH model.
Measured value deviations for temperature and humidity due to sources of interfer-
ence (see chapter
Installation location
) must be corrected in the ETS in order to ensure
the specified accuracy of the sensor (offset).
During
temperature measurement
, the self-heating of the device is taken into con-
sideration by the electronics. The software compensates the self-heating by reducing
the measured temperature. During the 2 hour warm-up phase, the displayed interior
temperature measured value increasingly approaches the actual room temperature.
2.
Installation and commissioning
2.1. Installation notes
Installation, testing, operational start-up and troubleshooting should
only be performed by an electrician.
CAUTION!
Live voltage!
There are unprotected live components inside the device.
•
National legal regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
Shelf life for the alarm
max. 2 years
Temperature sensor (Salva KNX TH):
Measurement range
-10…+60°C
Resolution
0.1°C
Accuracy*
±0,5°C at -10...+60°C
Humidity sensor (Salva KNX TH):
Measurement range
0% RH … 90% RH
Resolution
0.1% RH
Accuracy
± 7,5% RH at 0% …10% RH
± 4,5% RH at 10% … 90% RH
