elsner elektronik 70121, Установка и настройка

Страница: 12 / 26

10 Setting parameters
Temperature Sensor KNX T-AP • Version: 27.01.2020 • Errors excepted. Subject to technical changes.
6. Setting parameters
6.1. Behaviour on power failure/ restoration of
power
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block.
6.2. General settings
Since the application is used for several devices, the first settings are device-specific.
Please ensure that the following settings are selected for the
KNX T-AP
Set the basic data transfer characteristics and select whether or not malfunction ob-
jects should be sent.
6.3. Temperature measured value
Use Offsets to adjust the readings to be sent.
Use parameters and objects for
the humidity sensor No
Type of logic Logic for temperature sensor
Use parameters and objects for display No
Send delays after power-up and programming for:
Readings 5 s • ... • 2 h
Threshold values and switching outputs 5 s • ... • 2 h
Setpoints and control variables 5 s • ... 2 h; 10 s
Logic outputs 5 s • ... 2 h; 10 s
Maximum message rate • 1 message per second
• ...
• 5 messages per second
• ...
• 20 messages per second
Use malfunction object No • Yes
Offset in 0.1°C -50…50; 0