ELSEMA
Repeater for PentaFOB
®
and PentaCODE
®
remotes – Penta repeater
Block Diagram
Program Remotes
1.
Make sure power is connected to the repeater and the “Power ON” LED is on
2.
Press and hold the program button on the repeater
3.
Press the remote button for 2 seconds, TX LED will flash and then turn Green
4.
Release the button on the repeater and the remote
5.
Press remote control button to test.
Set the Repeater Address
If more than one repeater is used, each repeater should have a different address.
Do not have multiple
repeaters with the same address.
To change the repeater address Press “Up” or “Down” button. You can set
the address from 1 to 99.
The repeater address display switches “OFF” after some time. Press “UP” or the “DOWN” button to turn “On”
the address display.
The repeater closest to the receiver should be addressed as 1. Each repeater will repeat the signal from
another repeater which has a higher address than it.
For example: Repeater 3 will only repeat signals from repeater 4, 5, 6 and so on.
Code Change
Shorting these 2 pins for 10sec will delete
all programmed remotes.
