The musical tone indicates the camera is ready to scan the QR code created earlier by the App.
5.
Place the QR code at about 10cm in front of the camera lens.
6.
If the QR scan is successful, a musical tone will be heard. The camera will then attempt to connect to the
home network.
Note
: If there is no musical tone after 30 seconds, try moving the smartphone further away from the
camera in gradual steps.
Binding with ELRO Smart Home Alarm
1.
Log into the www.elro-smartalarm.com from a web browser.
2.
Under “System”, click on “Add a device” and select “Camera”.
3.
Enter the Access Code on the label behind the camera and click “Next step”.
*If camera is included in package
Testing the devices
1.
Firstly, close the window/door fixed with the magnetic contact detector.
Testing remote control, Voice Siren:
2.
Use the remote to arm the system. You should hear the voice siren talking.
Testing Magnetic Door contact, Solar Siren, App notification message
3.
Wait for 30 secs then open the window.
4.
The installation is successful if the voice siren issues a warning and then starts to sound within 30 secs.
5.
Use the remote control to quickly disarm the system. The siren should stop immediately.
6.
Check your smart phone or tablet. It should receive notifications from the ELRO Smart Home Alarm APP.
Testing PIR Motion detector
7.
Use the remote to arm the system again.
8.
Walk past the PIR.
9.
The installation is successful if the siren issues a warning and then starts to sound within 30 secs. Use
your mobile to disarm the system.
Testing Camera*
10.
Use the ELRO Smart Home Alarm APP and choose “Live”, select the camera, and the image can be seen.
*If camera is included in package
Troubleshooting
1.
Minimum distance
Please keep all accessories at least 30cm away from each other.
2.
Metal objects
Please keep accessories away from nearby metal objects as these may interfere with the radio signals.
3.
Environments with high concentration of radio signals
Environments with high concentration of electricity and wireless signals may interfere and limit the
maximum distance of accessories from the gateway.
4.
Internet connection problem
The gateway will periodically check internet connections. Try restarting the gateway if a problem occurs.
The gateway uses DHCP to get its IP.
5.
Battery status
Check the battery level of the devices if they are not responding properly. If the LED on the PIR and
magnetic contact detector blinks when they are activated, this means battery is low.
6.
Pairing
When the device is triggered but there is no response, a possible reason could be that the pairing during
factory setting has failed. Refer to the user manual for each device to perform manual pairing.
7.
Camera fail to connect to home network
If the web page indicates camera is not reachable, it could be the Wi-Fi information in the QR code set up
might be incorrect. Reset the camera and try again. To reset, use a sharp object (e.g. pin) to press the
reset button behind the camera for more than 10 secs and release. Then repeat the entire steps in the
section
Connecting Camera to home Wi-Fi
again.
8.
More information about devices
Refer to the user manual for each device.
Access Code
label
Содержание AS800011
Страница 1: ......
