SP105
1x6 VIDEO & AUDIO DISTRIBUTION AMPLIFIER
ELPRO Video Labs s.r.l.
Str.da della Pronda, 45/B 10142 TORINO - ITALY
Tel.+39 0117701583 – Fax +39 011703751
6
3.2 Audio
section
In a classic installation with a stereo signal to be distributed towards 6
destinations, follow the procedure described below:
a) Make sure that all the units to be installed are OFF.
b) Connect the stereo source to the AUDIO INPUT terminals.
c) Connect the destinations to terminals 1÷6
d) Power the SP105 and other system units.
WARNING
The ground terminal (GND) is
common to the L and R channels
WARNING
If the incoming signal is
unbalanced, connect the hot pin
to terminal "a" and the cold pin to
terminal "b".
Then, jumper "b" with GND
WARNING
The SP105 input is at high
impedance.
The input of several SP105 can be
set in parallel
WARNING
Output terminal "a" is in phase
with input terminal "a".
Output terminal "b"
is in counter phase in relation to "a"
WARNING
If the destination is unbalanced, connect terminal
"a" and GND.
Leave terminal "b" free or use it for another
destination
