DVIPRO1000
8x2 UNIVERSAL SCALER MATRIX SWITCHER
& EFFECT CONTROL
11
ELPRO Video Labs s.r.l.
St.da della Pronda, 45/B 10142 Torino ITALY
Tel.+39 0117701583 – Fax +39 011703751
11
4.2 Definition of input format
To define the format of the inputs, proceed as follows:
Press the “FORMAT” key on the front panel of the machine and, at the same
time, press the key relating to the input to be defined, using either the buttons
relating to OUT1 or OUT2: each time the key of the input is pressed, the
current assignment of the input will be shown on the LCD and on the video. In
this way, it is possible to scroll all the possible formats that can be assigned.
On releasing the “FORMAT” key, the DVIPRO1000 will make the
programming operative and if, at that moment, the channel reprogrammed
was displayed, will refresh the display.
With regard to input 8, if this is used in HDMI format, the related digital audio
stream inserted in the HDMI signal will be automatically decoded by the
DVIPRO1000. If the audio is to be provided separately in analogue format on
input 8 audio, input 8 must be programmed as DVI format.
WARNING
Format changing is possibile only in Fading Mode.
In Mixer and Cut Mode the operation is not permitted
4.3 Source selection
To select the inputs, use buttons 1 to 8 relating to outputs OUT1 and OUT2
on the front keyboard. Switching is performed in a programmable time of 0 to
3 seconds according to Fading, Mixer or Cut mode.
If the input selected is VGA analogue format, at initial power-on of the
machine, an automatic “AUTOADJUST” procedure will be performed for
improved centering of the image on the screen: subsequent switching
operations will not require this phase except in the case in which the format of
the source in input is modified or if it is connected to a new VGA source.
During this phase , the key of the interested channel will blink fast.
4.4 Activation of the PIP and selection of its source
To activate the PIP on an output channel, proceed as follows:
Press the key relating to the channel currently present on the MAIN; holding
down the key, also press at the same time the key relating to the input that is
to be displayed in PIP: the window will be activated to the bottom right.
Subsequently, from the remote control or using serial commands, it will be
possible to modify the size and position of the MAIN and PIP windows (see
paragraph 6.1.2 and paragraph 7.4).
If repeated, the same operation to activate the PIP will cause de-activation of
this.
