PS710 | INSTRUCTIONS FOR USE
9
Use of PS710R
This version is made without electronic control system which limit the possibilities to give
information to the operator about pump status. Crimping starts by pushing the start switch
on the handle, interrupting the crimp movement by releasing the start switch and at any time
stopping the pump and retracting the crimp tool with the stop switch on the handle.
A complete crimp cycle is made automatically with pressure built up to a preset max pressure
when the tool retracts and hydraulic is unloaded. Main switch should be turned off when the
pump is not used.
8. Maintenance / Service
The life time of a PS710 is prolonged if the unit is kept clean and dry. A daily check of
hydraulic hose, handle with signal cable, signal connectors and mains cable is important.
If damages occur, these components must be replaced before using the pump as it affect personal
safety. When hydraulic hose and cable are disconnected from the pump the plastic cover caps
must be mounted on the connectors.
Best way to transport and keep the pump protected is to use the Elpress wooden box.
The Li-ion battery only for PS710E should be kept dry and protected from short circuits.
All battery charging should be made indoor, temperatures between 0-30 °C. See charger
instruction.
TROUBLESHOOTING
Display or switches do not function
Check mains outlet power fuse and than
cable and connector. Test with battery power,
only
PS710E
ERROR MESSAGES DISPLAY
Stop button stuck
Signal cable not connected or damaged
Battery low
Charge or change battery
Motor temp high
Improve air ventilation around pump
Log memory full
Use “Clear logs” in main menu
High motor current
Contact Elpress
Time for service
Time for preventive maintenance
