PS-RS02
All details and specifications shown in this document are deemed correct at time of publication. The right to modify
equipment, change specifications and instructions without notice, is reserved as part of the Emergency Lighting
Products Limited policy of continuous development and improvement. We endeavour to keep all our customers
informed of any alterations as and when they occur.
TECHNICAL DATA: 08/2013
Microwave Motion Detector
The
PS-RS02
sensor is an active motion detector with
adjustable sensitivity, daylight detection and ‘On’ period.
The detector emits high-frequency electro-magnetic
energy (5.8GHz) and receives the echo from movements in
the detection zone. An internal microprocessor then triggers
and connects the load to the supply (‘On’ command).
The advantage of Microwave detectors is that movement
can be detected at quite long distances (up to 10metres)
and is possible through thin metal and typical materials used
in buildings (office partitions, etc.).
Microwave detectors are ideal for switching lighting load and
can be used for switching lights on or (by using dimming
ballasts) from a dimmed level to full output when someone
enters an area.
While there is movement in the area, the sensor will hold
the load on. The sensor can be adjusted so that when
movement stops the load will switch off (or return to
dimmed level) after 8 seconds to 12 minutes.
GENERAL SPECIFICATION
Supply voltage
230V 50Hz
Transmission system
5.8GHz CW radar, ISM band
Transmission output
<0.2mW
Maximum load
1200W (resistive) 600W (inductive)
Detection angle
360°
Range (Clear area)
2 - 10m adjustable
‘ON’ period
8 sec to 12 min
Lux detection
2 - 2000 Lux
Parasitic load
0.5W typical
Dimensions
75mm (L) x 42mm (W) x 44mm (H)
Fixing centres (Lugs)
84mm
