Active Sensor
figure 1
IR receiver /
Spare cleaning button
Important Notice
※
Ensuring Activation of the Product
Function buttons can only be activated while the active sensor (please refer
to figure 1) is initiated.
※
Water Comes out near the Nozzles
1. If water comes out near the nozzles, there are two possibilities:
a. Nozzles self-cleaning
b. Releasing remained water in the pipe
※
Nozzles Self-Cleaning and UV Sterilization (Option)
1. Nozzles self-cleaning will be activated automatically before and after each use.
2. Sixty seconds after each use, UV light will be activated automatically. The
sterilization process will be lasting for three minutes.
※
Low Water Pressure
1. If the user feels the water temperature increase rapidly at low water pressure,
please lower the water temperature setting immediately to prevent possible
skin burn.
2. Please check the following for trouble shooting:
a. Supply of water : Ensuring the source of the water is working normally.
b. Shut-off valve : Ensuring the valve is opened properly.
c. T-valve filter : Ensuring the filter is not blocked.
09
1 2
Europe
or
USA
connect water
shut-off valve
connect water tank hose
connect to
seat
(with filter)
Step 2. Connect T-valve and Hoses
The T-valve is required to install properly as
the build-in filter keeps out the impurities from
the tap water. Failure to do so could result in
leaking.
Step 3. Install Mounting Plate
The mounting plate and washers must be
assembled correctly as instructed.
Screw
Washer
Metal Plate
Mounting Plate
Plastic Nut
Step 1. Before installation
1. Remove the existing toilet seat.
Steps may vary by type of seat.
2. Close the water supply shut-off valve near
the wall and flush the toilet to empty the
water tank.
Turn the water supply
shut-off valve clockwise
Step 4. Attaching & Detaching the
product
Slide the product onto the mounting plate. You
will hear a “Clicking” indicating the seat has
been properly attached.
Step 5. Pre-Test
1. Slide the seat onto the mounting plate.
A ”clicking” sound indicating means that the
seat has been mounted properly.
2. Turn on the water valve in place. And then
enjoy your One Touch electronic bidet.
Installation
