Elnec BeeHive304, Руководство пользователя

Страница: 30 / 152

Elnec s. r. o.
30
Introduction
BeeProg3 is next member of Elnec universal programmer series, built to meet the strong
appeal for an extremely fast and reliable programmer for high-capacity memories.
BeeProg3 is designed with great emphasis on technical perfection and speed of hardware,
this programmer perfectly fits for high-demanding desktop programming as well as for
automated programming systems and ATE machines, where ensures the highest quality
and overall yield.
BeeProg3 programmer core is based on a state of the art FPGA , powerful ARM processor
and internal SSD to be ready to program devices at theoretically possible speeds. The
achieved
ultra fast programming speed - more than 22,5 MB/s continuously - is actually
higher, than real devices supported so far can utilize. This is reflected in extremely short
programming times. For example, the 2 GB eMMC NAND Flash could be done in
less than
100 sec - if programmed memory allow that speed.
Tests show, the BeeProg3 is currently faster than all competitors in this price category
(status: 10/2014), for many chips it the fastest at all.
BeeProg3 supports all kinds of types and silicon technologies of today's and tomorrow's
programmable devices . It partially supports also devices "from yesterday". You can be sure
that the next devices support will require the software update only, at the most (if necessary)
simple programming module, therefore
the cost of ownership is minimized . You have a
freedom to choose the optimal device for your design.
For the proper and reliable programming of ultra-fast memories the BeeProg3 utilizes
specialized modules, optimally designed for specific device families, exactly according to
the needs of programmed devices. But if it is possible, then universal programming modules,
dedicated for IC package type, are used. The programming modules are identical for all
programmers based on the BeeProg3 programming core (BeeHive304 for example).
Programming modules construction is designed for perfect stability at the top of the
programmer, to be tough enough for insert/replace chips by mechanical arm and also allows
keeping identical position of ZIF socket also after replacing of the module.
BeeProg3 interfaces with any IBM PC compatible personal computers, running MS Windows
OS, through USB (2.0 High Speed) port or 100 Mb LAN port (via switch or router).
With its very competitive price together with excellent hardware design for reliable
programming, it is probably the best "value for money" programmer in this class.
The 64-pin rich-features, precise and powerful pindriver of BeeProg3 deliver high speed,
accurate and clean waveform signals to the device by eliminating noise, ground bounce and
overshoot, which maximizes programming yield and guarantees long data retention. This also
allows the reliable support of virtually any nonvolatile technology used for programmable
devices - (E)EPROM, Flash, MRAM, PCM, ... - by a single device programmer.
FPGA based totally reconfigurable TTL pindrivers provide H/L/pull_up/pull_down and read
capability for each pin of the device. The dual H/L drivers enables to provide two different H
levels for both core signals and I/O signals of programmed device without additional logic.