ELNA Sew Fun, Инструкция по эксплуатации

Страница: 23 / 30

21
1
4
2
3
4
2
q w e
r
z x
c v n
m
q
w
q
Pattern selector:
w
Presser foot: Buttonhole foot
e
Thread tension: 1–5
r
Stitch length:
Buttonhole
To adjust buttonhole stitch density:
Set the stitch length dial between 0.5 and 1.0 to adjust
the buttonhole stitch density.
1 Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
2 Slide both threads to the left.
Line up the foot with the top mark on the fabric.
Lower the needle into the garment where the
buttonhole is to start, and lower the foot.
3 Set the pattern selector dial at “ ”.
Sew forward until you reach the front marking
q
of
your buttonhole.
Stop sewing at a left stitch.
4 Set the pattern selector dial at “ ”.
Sew 5 stitches. Stop sewing at a right stitch.
5 Set the pattern selector dial at “ ”.
Sew until you reach the back marking
w
of the
buttonhole.
Stop sewing at a right stitch.
6 Set the pattern selector dial at “ ”.
Sew a few bartacks and raise the needle from the
fabric.
Set the stitch length dial to “0” and the pattern selector
dial at straight sewing.
Sew a few locking stitches.
7 Remove the fabric from the machine and cut the
sewing thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
b