Lighting function and additional sounds (channel 3)
The control of the lighting and the additional sounds is made by
channel 3 (orange wire). The activation of the lighting control lead to a
cyclical change of the light condition as shown on the image.
Status LEDs
The status LEDs 1 and 2 on the PCB show the current operating status of the
ElMod 3to
. L1 provides information about the battery status
(undervoltage) and the connection status to the receiver. L2 informs about the sound output or errors with the identification or reading of the
microSD card. A permanent lighting of the status LEDs indicates the operating status of the
ElMod 3to
.
The most important flashing patterns of the central unit's status LED (L1):
on: central unit is ready to operate
LED goes out briefly and goes on again immediately: stick put out of the center
LED blinks quickly: receiver is being scanned, no connection to the receiver or signal invalid
LED blinks slowly (shortly on/longer out): communication with sound unit faulty
double blinking: battery error of the CPU (undervoltage or short battery disconnection)
short blinking every 5 seconds: cut off/shut down due to undervoltage. The battery must be charged or is damaged
single triple blinking: the center unit is in update mode ready to receive a new firmware
The most important flashing patterns of the sound unit's status LED (L2):
on: sound unit is ready to operate. The LED flickers when sounds are being played
LED blinks rapidly: microSD card faulty, not inserted, no sampleset found or sampleset faulty
LED blinking: no connection to the central unit. Please contact for support.
single triple blinking: the center unit is in update mode ready to receive a new firmware
1 Please check if your RC and receiver work. Check the correct function with a servo or the ElMod App.
2 If this error doesn't disappear after a restart, please contact your dealer for support.
3 Turn off the electronics for 10 seconds. If the error still exists please ensure that the Configurator is not connected and restart again
© ElMod - 20-01-02
