ELMO Mfg. Corp.
1478 Old Country Road, Plainview, NY 11803-5034
Tel.: (516) 501-1400
Fax: (516) 501-0429
Installation Guide
1
¼
¼
¼
1
14
5
7
13
3
8
10-11
12
2
4
9
5
6
6
5
4
3
2
1
Installation
Steps for ELB-3610 series
** Do not remove immediately the plastic film on the lower dome section. Install the wall bracket (EWB-3610)
or ceiling bracket (ECB-3610). Make sure it is safely secured in place.
a)
Use a Philips #1 screwdriver, release the four screws holding the lower dome to the upper dome section (
see #1
).
IMPORTANT: 1/4 turn counter-clockwise to unlock each screw (
1
).
Carefully remove the lower dome (use a light twisting movement if needed to undo).
b)
Attach the upper dome section to the mounting bracket (
2
).
c)
Remove the mounting plate (
3
). Pull cables through the bracket (
4
). Fix the camera to the mounting plate (
5
).
d)
Connect the 24vac power cable to the "AC IN" terminals (
6
). Insure that the transformer isn't connected to the 120vac
source at this time (input: 24vac, 100va).
e)
Connect the jumper cable (12vdc) to the camera (
7
), and connect RCA connector to the camera (
8
) when using the PTC-200
If the PTC-201C IP model is being installed, connect the communication cable to the camera (
9
).
f)
For PTC-200, insert the mounting plate & camera assembly in location # 3 inside the dome (
10
).
For PTC-201C IP, insert the mounting plate & camera assembly in location # 5 inside the dome (
11
).
NOTE: While installing the mounting plate back in the dome, you may have to move the adapter to level the mounting plate (
12
).
g)
Check all connections before connecting the transformer to 120vac. If the camera doesn't work, verify the fuse (
13
) and the
h)
Fix the lower dome section back in place and secure the four screws. IMPORTANT: 1/4 turn clockwise to lock each screw (
14
).
Remove
the
protective film off the lower dome.
Optional Heater Board
d
Power Supply
pp
Outdoor Dome for ELMO
PTC-200 & PTC-201C IP
Mounting plate
nting plate
Moun
on #
locatio
P
re-wired
/ Do not use