LED BLINK RATES
Respective scene/switch is on and the respective
scene setting is disabled (DIP switch 6 and/or 7)
3 Second OFF Flicker
Respective scene/switch is on but overridden
3 Second ON Flicker
Respective scene has been recorded
2 Flashes
Record scene mode attempting to be entered
without a DMX input present
2x Blink
Respective scene is ready to record
2x
RDM data detected
2x Flash
Respective scene is selected
1x
DMX Input data overrun error has occurred
since last powered or DMX connection
1x
Respective Switch/Scene is On / Active
ON
Valid DMX is being received
ON
Respective Switch/Scene is Off
OFF
No DMX is being received
OFF
Description
Rate
Description
Rate
SCENE LED’S
DMX LED
SCENE RECORDING
NOTE: If Dip Switch 7 (Merge) is on, upon entering the PGM Scene Recording mode, all switch settings will be turned
off while programming and will resume upon exiting. To prevent a blackout, preset a DMX scene before entering the
PGM Scene Record mode.
1.
Insure a valid DMX signal is present indicated by the DMX input LED on.
2.
Preset a desired look from the DMX lighting board or DMX generating device.
3.
Enter the PGM Scene Record Mode: Press and hold the PGM button for 3 seconds, the 1st scene will be selected
and will blink at a 1x rate
. (NOTE: If Dip Switch 7 [DMX/Switch Merge] is ON - Switches will be temporarily disabled and
turned off while in the PGM Scene Record Mode.
)
4.
Select the desired scene to record by tapping the PGM button until the desired scene LED is blinking, (to exit the
record scene mode tap 4 times).
5.
Press and hold the PGM button 3 seconds to confirm selection, the scene LED will blink at the 2x rate. (To exit the
scene record mode tap the PGM button.)
6.
Insure the scene (seen in real time) is the desired ‘look’ to be recorded, make any changes from the DMX lighting
board or DMX generating device.
7.
Press and hold the PGM button for 3 seconds to record the scene. Two flashes on the respective LED will indicate
confirmation of the record.
To abort storing, tap the button for 1 second and release.
Repeat steps to record each scene.
While in the scene record mode inactivity for 30 seconds will automatically cancel and exit.
DMSC - DMX Multi Station Controller User Guide
Pg 4
ELM Video
Technology
DMSC-DMX-Multi-Switch-Station-Controller-User-Guide V2.03.lwp
www.elmvideotechnology.com
copyright
©
2015-2017 ELM Video Technology, Inc.