page 9
10. Automated Learning Process./
Activating Code.
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
This remote control transmitter is equipped with
16 code combinations to prevent possible
interference from or to other remote units such as
garage door openers, car alarms or security systems. If
you find that your fan and light go on and off without
using your remote control, simply change the
combination code in your remote control (transmitter
and wall control).
To set the code, perform the
following steps:
Remove battery cover from back side of transmitter.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 for the transmitter.
Use the
same number sequence used when wiring the wall
control in Section 6.
Note
: Since this fan comes with LED bulbs, the
dimmer switch (labeled
D
and
X
) has been pre-set to
the "ON" position (
D
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
X
).
Install 9-volt battery (included) in transmitter and
then re-attach the battery cover.
[
IMPORTANT
: To prevent damage to transmitter,
remove the battery if not used for long periods.]
Restore electrical power and then set slider switch on
wall control to the ON position. Within 30 seconds of
turning on the wall control, press and hold the "OFF"
button on the front of the transmitter for 5 seconds or
until light on fan blinks twice. Test the fan and light
functions to confirm the learning process is
complete--see Section 13.
11. Wall Control Operation.
ON/OFF slider switch
- turns
wall control
ON or OFF
HI
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
FAN OFF
button - turns
fan
OFF
LIGHT
button - turns
light
ON/OFF when pressed
once; dims
light
when pressed and held down
TRANSMITTER
(front)
dimmer
switch
code
switches
1
TRANSMITTER
(back)
battery
battery
cover