MADE IN TAIWAN
QUICK GUIDE
DS80HA07-002A
ENGLISH
S600
LIGHT - TEMPERATURE - HUMIDITY SENSOR
Light Sensor / LED Indicator
Flashes once:
Factory Reset
Flashes twice:
After the sensor has successfully
joined a network.
Flashes 3 times:
Battery inserted.
Flashes 5 times:
Low battery detected when
inserting battery.
Flashes once every 20 minutes:
The sensor has
lost connection to its current network.
Self adhesive mounting
1. Clean the surface with a suitable degreaser.
2. Remove the protective covering from one side of double-sided adhesive pad and firmly
apply to the back of the device.
3. Remove the other covering and firmly place/press the device in the desired location.
Do not use the Self-adhesive mounting method on poorly painted and/or rough surfaces.
Screw Mounting
1. Detach the Top Cover by loosening the Cover-Fixing Screw.
2. Break through the knockouts on the base.
3. Use the holes as a template to drill two holes and insert the wall plugs and screw the base into the wall plugs.
4. Replace the top cover over the base by hooking the base onto the fixing hook and pushing the cover towards the base.
Joining the Network
Please follow the steps below to join the Sensor into the network.
1.
Connect the Sensor to power cable.
2.
Set the control unit to learning mode (see the instruction manual of the control unit for details).
3.
Press and hold the Function button for 10 seconds, then release it to join the network. If the device successfully joins
the network, the LED Indicator will flash twice to confirm.
Removing Device from Network (Factory Reset)
Factory Reset function can clear the device of its stored setting and information and prompt it to search for new network.
1. Press and hold the function button for 10 seconds, then release the button to reset the Sensor.
2. The device will perform its factory reset.
3. Fully follow the previous instructions to join again the device
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, URMET S.p.A. declares that the radio equipment type: LIGHT SENSOR S600
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.elkron.com
.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT
TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by
handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The
separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the product.
ELKRON
Tel. +39 011.3986711 - Fax +39 011.3986703
www.elkron.com
– mail to: [email protected]
ELKRON
is a trademark of
URMET S.p.A.
Via Bologna, 188/C - 10154 Torino (TO) – Italy
www.urmet.com
Light Sensor / LED
Battery
Compartent
Function Button
Temperature Sensor
