4/8
ADDRESSING
The address (1-128) is software set and stored
in a non-volatile memory.
The FM500 can be addressed, in manual or
automatic mode from the Control Panel.
For further details see the Control Panel’s
programming manual.
CONNECTIONS
A shielded cable must be used
: connect the
shield of the cable (one end in a loop mode) to
the ground in the control panel only and connect
the shield between a device.
The section of leads can vary according to the
length of the detection line.
A lead section of 1.5 mm
2
is advised.
Don’t use cable that exceed these limits:
Maximum resistance = 100
Ω
Maximun capacitance = 2 µF
The electrical connection must be performed by
removing approximately 10 mm of insulating
cover from the main lead and insert it on the
terminal block.
Fig. 3
– Connection diagram
The
FM500
is only to be used with ELKRON
FAP series Control Panels.
TESTING
(trained personnel)
Before testing, notify to competent authority that
the system is temporarily out of service due to
maintenance operations.
The manual call point can be tested by pressing
on the operating face and verifying the alarm
condition.
At the end of testing operations, restore the
system to normal operation and notify the status
to the competent Authorities.
TECHNICAL SPECIFICATIONS
Operating voltage
20 Vdc (-15%, +10%)
modulated
Average power
consumption
(Normal condition)
250
A @ 20Vdc
Average power
consumption
(Alarm condition)
2 mA @ 20Vdc
Bi-Colour LED
Red steady:
alarm condition
Red blinking slow (2s):
alarm condition with SLC
operating voltage < 17V
Green blinking slow (2s):
normal condition
Green blinking fast:
duplicate address
Operating temperature
-10
55°C ± 2°C
(14
131°F)
Relative humidity
93 % ± 2%
non condensing
Storage/shipping
temperature
-30
70 °C
(-22
158°F)
Alarm condition
Type A
Enviromentals class
Inside
Dimensions
110x110x42 mm
Weight
140 g
Enclosure material
ABS V0
In compliance with EN54-11: 2001/A1:2005
EN54-17: 2005/AC:2007
Resettable Manual Call Point FM500
Urmet S.p.A. 1293-CPD-0337
DoP n. 1293-CPR-0337
Further information are available to the manufacturer.
09
1293
