36
Installation/Configuration ER600
10 - SYSTEM COMMISSIONING
10.1 ARMING USING RC600 REMOTE CONTROL
10.1.1
Total arming
The remote control must have been duly programmed for all partitions to arm all the partitions in the system.
Press the
on the remote control to arm all partitions. If the control unit has accepted the command, the LED will light up red and
then green.
10.1.2
Partial arming
The partial arming of only some partitions in the system is possible only if the remote control is duly programmed to do so.
Press
on the remote control to arm the partitions to which the remote control is assigned. If the control unit has accepted the
command, the LED will light up red and then green.
10.2 DISARMING USING RC500 REMOTE CONTROL
10.2.1
Disarming
The remote control must have been duly programmed to disarm all the partitions in the system.
Press
to disarm the system totally or partially using the remote control. If the control unit has accepted the command, the LED will
light up red and then green.
10.3 DIRECT ACCESS FUNCTION KEYS
10.3.1
RC600 remote control programming key
During pro
gramming, the “
+
” key on the remote control may be configured to activate or deactivate a specific output to access one of
the following technological functions (fire, emergency, panic, silent panic) directly. Hold the “
+
” key pressed for at least five seconds to
generate the respective event.