Elkron ER500, Руководство по установке и настройке

Страница: 23 / 44

Installation/Configuration ER600 23
6.10 TROUBLESHOOTING
Failures and malfunctions are identified by specific messages of the failure memory and the Diagnose Log. The table below contains
the messages that are visualised, the possible causes of the failure or malfunction that occurred, actions to take to find the problem
and resolve it.
MESSAGE
FAILURE MEMORY
MESSAGE
DIAGNOSE LOG .
CAUSE FINDING AND RESOLVING THE PROBLEM
ANOM. BUS
ERnn.ER xx FAILURE STARTS BUS
ERnn.ER xx
FAILURE BUS
CONNECTION The bus device signalled
is not communicating
(expansion), that control
panel has not been
answered.

Check the cabling of the device/s at the bus (disconnected wires or
short circuits or inverted polarity.

Check the bus power supply.
BATTERY LOW
ERnn:DCmm
ERnn:IRmm
ERnn:RCmm
ERnn:HPmm
ERnn:KPmm Radio devices battery flat Replace the battery.
7 - CONFIGURATION
CONVENTIONS USED
The following conventions are used in the manual for the sake of simplicity:
This is the LCD with the displayed message.
Unless otherwise specified, the same message is shown on the touchscreen keypad.
, , , ,
…
This is the equivalent key to be pressed on the keypad.
< Master code >
< User code >
< Installer code >
< Technical Manager code > This indicates the code to be entered using the keypad.
< Master / User code > This means that either code may be entered on the keypad indifferently.
H24 This means that the described function or service is always active.