Installation/Configuration ER600
19
6.6
ACQUISITION/ MAINTENANCE OF THE RADIO DEVICES
As soon as the control panel acquires the first ER600 expansion (see paragraph
5.1 ACQUISITION OF BUS DEVICES
), the specific
menu to acquire and configure radio devices will appear on the system keypads.
Below is a diagram of the navigation flow of the “Radio Devices” menu.
Figure 6 - Radio devices menu diagram
After entering «Radio devices»
→ «Acquire» menu, the control panel and the ER600 expansion are ready to acquire devices.
When the acquisition request arrives from a radio device, the control panel proceeds to acquire it and the type of radio devi ce and its
address appear on the keypad (for example: “IR01”).
If it has acquired a number of radio devices equal to the maximum, the control panel will not allow the acquisition of others. In this
specific case, the keypad in acquisition will continue to show the date of the last device acquired and emit an error signal (a long beep).
Suggestion:
Device acquisition is progressive. Therefore if they are to be matched to inputs and outputs in a certain order, the
precise sequence must be defined before carrying out the acquisition procedure.
IMPORTANT!
If there are two ER600 expansions, the devices must be acquired separately. The same device
must not be
acquired on both expansions.
Maintenance
Acquire
Delete
Radio Device
Acquire
Configuration
Cancellation
Selection ER600
Acquire
INPUT Device
IR/DC/RC/KP
Acquire
OUTPUT Device
Siren radio
Acquisition
IR/DC/RC/KP
In progress
Acquisition siren
Radio in progress
Selection ER600
Supervision
Jamming
Disarmed
4 / 6 / 8 / 10 / 12 hours
Disarmed
Armed
Selection IR
Selection DC
Selection RC
Selection SIREN
Cancel IR 0?
Cancel DC 0?
Cancel RC 0?
Cancel SIR 0?
}
Wired System Menu Options
Selection KEYPAD
Cancel KP 0?