Installation/Configuration ER600
15
5 - COMMISSIONING
5.1
ACQUISITION OF BUS DEVICES
5.1.1
Position of the programming buttons
For the acquisition of the bus devices, use their programming buttons (PROG). In the figure below, where is the radio expansion.
Figure 5 - Position of the programming buttons
.
5.1.2
Procedure for acquiring bus devices
IMPORTANT!
The instructions below assume that the devices have not yet been acquired.
Otherwise, see Chapter 6 -
To acquire the various devices on the system bus, follow the instructions below:
1. Select the keypad to be used to acquire system devices from among the keypads present in the system. It is also possible to use
the service keypad.
2. Press the programming button (PROG) on the keypad display.
The control panel registers it by assigning the “KP01” address. If it
is a service keypad, it will be assigned the address “KP08”.
3. The «MAINTENANCE» / «LINGUA-LANGUAGE» menu will appear on the keypad display.
If the language is to be changed, press the
OK
button, otherwise press the ▼ key until «MAINTENANCE» / «ACQUIRE» appears,
press
OK
again and go on to point 7.
4. «LINGUA-LANGUAGE» / «KP01:KP 01» appears on the display (second line). KP01 is the first keypad of the system, or the one
that was just acquired. If the service keypad is being used, the message «KP08:KP 08» will appear. Press the
OK
button.
5.
«ITALIANO» will appear on the display. Use the ▼▲ keys to select the language desired and confirm the selection by pressing the
OK
key.
6. «Download in progress >>>>...» will appear on the display. When the download of the new language is complete, the message
«DOWNLOAD OK» will appear. Press
OK
and then
ESC
.
IMPORTANT!
During the download, the power supply must absolutely not be disconnected from the keypad!
7.
“ACQUISITION IN PROGRESS...” will appear on the display and the control panel is ready to acquire other devices.
8. Proceed with the acquisition of the other devices by pressing the programming button of each of them.
The yellow LED located next to the button of the device will turn off as soon as it is acquired.
Each time a new device is acquired, the keypad emits 3 beeps and the device type will appear on the display (ER = radio
expansion).
Once the acquisition of all the devices is complete, press
ESC
to exit from the menu.
IMPORTANT!
If the ER600 is not acquired, check that the control panel and all the installed keypads run SW version equal to
or higher than 1.05.
Now it is possible to proceed with the system configuration.
IMPORTANT!
The addresses are assigned progressively and according to family of belonging; it is not necessary to follow a
pre-established order. If the operator wants the device addresses to follow certain logic, they must be acquired in that order.
Suggestion:
Take note of the address of each individual device on the labels provided with the control panel.
RADIO EXPANSION
