en
Tablestand for SmartHUB
For your safety
NOTICE
RISK OF DAMAGE TO DEVICE
Always operate the product in compliance with
the specified technical data.
Failure to follow these instructions can
result in equipment damage.
Getting to know the product
The Tablestand for SmartHUB (the
tablestand
) is
used as a holder for the ELKO SmartHUB.
Using the tablestand
Installation and removal
To install:
1
Insert the SmartHUB into the tablestand,
observing the correct orientation.
2
Place the SmartHUB face-down on a clean,
flat surface.
3
Press each buckle around the SmartHUB
bezel until it clicks.
4
Connect cables as required, then place the
SmartHUB on the desired surface as shown.
To remove:
5
Disconnect the SmartHUB cables.
6
Place the SmartHUB face-down on a clean,
flat surface.
7
Use a small flat-bladed screwdriver to
carefully release each buckle around the
SmartHUB bezel.
8
Remove the SmartHUB from the tablestand.
Technical data
Operating
temperature
-10 °C to 45 °C
Relative humidity
10% to 95%
Product
dimensions
(H
×
W
×
D)
86 × 54.6 × 86 mm
ELKO
ELKO AS, Sandstuveien 68, 0680 Oslo
Phone.: +47 67 80 73 00 - E-mail: [email protected]
Pb. 6598 Etterstad, 0607 Oslo
www.elko.no
7
8
GDE12280-00
12/2019
ELKO Smart
EKO09742
en
fi
4/4
1
2
3
5
12 V DC
USB
Power
4
6