1 / 2
DIM-2
02-190/2016 Rev.: 0
3
1
2
4
5
6
7
8
9
10
11
A2
A1
V
T1
T2
h
T2
A1 V
A2 T1
N
L
T 2.5 A
R, L
a
b
c
d
e
f
R
L
C
x
x
xx
xxx
z
z
-
-
-
z
-
230V AC
ELKO EP, s.r.o.
Palackého 493
769 01 Holešov, Všetuly
Czech Republic
Tel.: +420 573 514 211
e-mail: [email protected]
www.elkoep.com
Staircase switch with dimming
Characteristics
Description
Symbol
Connection
EN
•
designated for dimming el. bulbs, halogen lights and halogen lights with winding
transformers
•
intelligent control of halogen lights, function of gradual switching on and dim-
ming
•
controlling inputs for push button and switch
•
values are set by potentiometers on front panel of the product, adjustable:
- maximum dim-up
- speed (fl uency) of dim-up
- speed (fl uency) of dim-down
- time for which a light is on with maximum dim-up
•
all time intervals can be adapted according to a request
•
output without contact: 1x triac
•
load AC 5b (el. bulbs) 500 W
•
clamp terminals
•
parallel connection of controlling pushbuttons is possible
•
protection against over-temperature inside the product - switches output off +
signalizes overheating by LED fl ashing
•
1-MODULE, DIN rail mounting
•
Note: possibility of start and fi nish adjustment up on 1 hour, device has descrip-
tion DIM-2-1h
1. Output
2. Supply voltage terminal
3. Control input for push button - is a
service switch (possibility to switch a
light on permanently)
4. Output indication - red LED:
- start - LED fl ashes in medium pace
- delay - LED is on
- end - LED slowly fl ashes
- temperature overload - output dis-
connected, LED fl ashes quickly
5. Supply voltage indication
6. - brightness setting: 10 - 100%
7. t1 - dim-up time setting: 1 - 40 s
8. t3 - dim-down time setting: 1 - 40 s
9. t2 - time dwell setting: 0 s - 20 min
10. Supply terminals
11. Controlling input for switch - to
control dimmers (for example in
staircases). This input is protected
against undesired button blocking (for
example by a match). Length of button
pressing doesn´t infl uence length of
cycle.
T 2.5 A - ballast protection recommended
When load is above 300 VA it is necessary to ensure suffi
cient cooling.
Recommendation for mounting: leave a gap of min. 0.5 module (approx. 9 mm) on side
of the device to ensure better cooling of the device.
a) lamp,halogen light
b) low-voltage el.bulbs 12/24V wound transformers
c) low-voltage el.bulbs 12/24V electronic transformers
d) LED bulbs
e) saving fl uorescent lamps
f) switching management
x - dimmable
xx - incline edge
xxx - descending edge
Product loadability
