Insert side spray hose (1) through hose guide
and sink. Align block (2) and tabs (3) on quick
connect (4). Push quick connect housing firmly
upward and snap onto receiving block. Pull down
moderately to ensure connection has been made.
If it is necessary to remove quick connect,
squeeze tabs on hose between index finger and
thumb, then pull down to disconnect.
Make connections to water lines. Use 1/2" I.P.S.
faucet connections (1) or use coupling
nuts (3) with 3/8" O.D.ball-nose riser (2).Use
wrenches to tighten connections.
Do not overtighten.
Important: After installation is completed, remove
aerator assembly. Turn on hot and cold water
supplies. Turn handle to full open position for one
minute. Check for leaks. Replace aerator.
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
2
3
4
1
1
3
2
