WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
Shut off water supply at angle stop.
Clean sink surface in preparation for
new faucet.
If your model has a spray, proceed
to step 2. If your model does not
have a spray skip to step 4.
Place faucet in position on sink.
From underneath sink, install rubber
washer (1) and metal washer (2)
onto the threaded mounting shank.
Thread nut (3) onto mounting shank.
Do not overtighten.
STEPS:
For models with spray:
Insert spray hose down through the
support and sink. Attach the spray hose to
the connection beneath the faucet by
aligning the tabs on quick connector. Push
quick connector housing firmly upward
and snap onto receiving tube tab. Pull
down moderately to ensure connection
has been made.
If it is necessary to remove the quick
connector, squeeze tabs on hose between
index finger and thumb, then pull down to
disconnect.
Make connections to water lines.
Use 1/2" I.P.S. faucet connections (1)
or use coupling nuts (3)
with 3/8" O.D.ball-nose riser(2).
Use wrenches to tighten connections.
Do not overtighten.
1
Important: After installation is completed,
remove aerator assembly. Turn on hot
and cold water supplies. Turn handle to
full open position for one minute. Check
for leaks. Replace aerator.
3
2
For models with spray:
Insert spray support through far right
hole on sink. Screw hold - down nut
(1)onto shank and hand tighten.
Place faucet in position on sink.
Install rubber washer (2) and metal
washer (3) onto the threaded
mounting shank. Thread nut (4) onto
mounting shank. Do not overtighten.
2-Ø1 3/8" (Ø35mm)
2
4
3
1
