Page 2
1000003845 (REV. B - 05/17)
WARNING
CAUTION
•
Do NOT use the dispenser if the cord becomes frayed or otherwise damaged.
•
To protect against electric shock, do NOT immerse cord, plug, or any other part of dispenser in water or other liquids.
•
Ensure the dispenser is unplugged prior to cleaning. Never use organic liquid to clean the machine. Strictly prohibit splashing water to the unit.
•
Never turn the machine upside down or lean it more than 45°.
• This machine should not be turned on until 3 minutes after turning off the power switch.
•
Never allow children to dispense hot water without proper and direct supervision. Unplug unit to prevent unsupervised use by children.
•
Service should be performed only by a certified technician.
Features and Functions
Item No.
Description
1
Bottle Supporter
2
Power Pilot Lamp
3
Heating Pilot Lamp
4
Cooling Pilot Lamp
5
Cold Water Tap
6
Hot Water Tap
7
Water Drain Tray
8
Power Cord
9
Outlet of Hot Water
10
Compressor
Installation
For correct and safe installation, please read these instructions completely.
•
All Installation work must be performed by an authorized service personnel.
•
Disconnect electrical supply serving the Installation area to reduce risk of electrocution.
•
Unit not suitable for installations where water jets could be used.
DANGER
•
Ensure proper ventilation by maintaining clearance between condenser and wall.
•
Never wire compressor directly to electrical supply.
•
Warranty is void if Installation is not made in accordance with current Manufacturer’s instructions.
Remove the screw with a cross-head screwdriver, which is located in the middle of the rear side of the
base plate. (Ref. Fig. 3)
1.
Pre-drill a hole into the floor where the unit is to be installed.
2.
Fix the bracket to the unit using the screw that was removed in Fig. 3. (Ref. Fig. 4)
3.
Secure the unit to the floor using the pre-drilled hole and surface appropriate hardware. (Ref. Fig. 5)
4. Tear the label from the bottle.
5.
Vertically insert the bottle into the bottle supporter on top of the machine. Do not plug the power
cord or push the heating switch until water runs out from the tap of hot water.
6.
Insert the plug to the socket and turn on the switch. Indicators will light up once the machine is working.
7.
When the bottle is empty, vertically pull it out with both hands and then replace it with another bottle
of water.
Mounting
Bracket
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
