CHARGING
The skateboard and controller must be fully charged before first use. Make sure both the skateboard and the controller are turned off during charging.
Note: Using another charger may damage the motherboard or battery and void the warranty.
Please contact us if you need a replacement charger.
•
Charging a skateboard
Use only the charger provided. Switch off the skateboard before
charging.
Plug the charging cable into the electrical socket on the skateboard.
The light on the charger glows red when charging and green when the skateboard is fully charged. After successful charging, remove the charging cable
from the socket.
A full charge takes 3 hours by default.
•
Charging the remote control
A standard micro USB cable is used to charge the controller.
Connect the included USB charging cable to the bottom of the remote control. Make sure you connect the cable with the
correct end.
Plug the other end of the USB charging cable into the charger and place it in the charging socket. The standard time to full charge is 2 hours.
PAIRING
The skateboard and controller must be paired before first use.
Step 1:
Before starting the process, make sure that both the controller and the skateboard are turned off.
Press and briefly hold the red button on the remote control until all the LED lights turn off.
Press and briefly hold the red button on the skateboard until all lights are off.
•
•
Step 2:
Press and hold the power button on both the skateboard and the remote control until you hear three beeps (one long beep and a
few seconds later two short beeps)
Step 3:
Turn off the skateboard. Turn off the driver. Turn both on again. The skateboard and remote control are now paired. If
the pairing was not successful, repeat the process from the first point until the pairing is successful.
GROOMING TESTING
You can test the pairing by placing the skateboard on the edge and pressing the motion control until the wheels start to rotate.
The skateboard is now ready for use.
BEFORE DRIVING
Before driving, always check the overall technical condition of the product and its equipment. Make sure the device is charged.
Wear appropriate safety equipment, sturdy shoes. Always adapt your ride to suit your experience and the environment in which
you move. Take care of your surroundings. Follow local laws and regulations. Drive safely!
FIRST RIDE
Turn on both the skateboard and the controller and check that everything works. Release the brakes by pushing the motion
control back. Step on the skateboard, balance and gently push the joystick forward before the skateboard starts. The more you
push the controller, the faster you drive. Push the joystick back to start braking. Practice driving slowly forward until you feel
comfortable. Then try turning. We first suggest learning with a friend so that you have support in the event of a fall. Most users
are able to drive in a short time. It's easier than you think!
BASIC TICKETS
Be sure to push the joystick back to brake when boarding the skateboard. This makes it easier to get on a skateboard. You should
place a foot in the back of the skateboard that you will bounce off. Put the other leg in front of the skateboard. The turn is the
same as on a classic skateboard. Make sure your ride is smooth and commensurate with your experience.
