Eliz EQH 120 DF, Инструкция по эксплуатации

Страница: 17 / 20

17
• The device requires no installation, it is necessary to use the heater as a portable appliance. The portable
appliances are not suitable for use in the bathroom! Do not have adequate safety coverage!
• Place the appliance on a flat surface, which ensures sufficient clearance for proper operation of ventilation
holes.
• The minimum distance of objects from the heater should be at least 1 meter.
Assemble the heater and the base plate together by following these steps:
1. Remove the four plastic head screws from the bottom of the heater.
2. Place the base on the heater in the designated place and fasten it with four unscrewed screws.
3. Check that the base is properly connected to th heater
• Before connecting and switching on the heater, check the heating tubes and make sure that the socket has
a fuse at least 10 A.
Power supply: ~ 220 - 240 V, 50/60 Hz ; Fuse: 10 A
The electrical installation, as well as the connection,
must be carried out under the applicable regulations
and standards.
The heater includes a flexible power cord with a 230 V
plug. Plug the power cord into a socket with ground
contact. Do not place the heater directly below a power
socket.
ELECTRICAL CONNECTION
HEATER LOCATION
ASSEMBLY
OPERATION
• Set the power rotary switch to position 0 and connect the device to the mains.
• Turning the power switch knob to position 1 turns on the device and also turns on
the first tube - power 300 W.
• By turning to position 2 , the second tube is switched on - power 600 W
- one side of the heater works.
• By turning to position 3 , the third tube is switched on - power 900 W
- one tube on the other side of the heater also works.
• By turning to position 4 , the third tube is switched on - full power 1200 W
- they play a set of both sides of the heater.
• To switch off the heater, turn the switch to position 0 and disconnect it from the mains.
Model :
EQH 120 DF
Rated voltage ~ 220-240 V , 50/60 Hz
Power 300 / 600 / 900 / 1200 W
Fuse 10 A
IP protection IPX0
Tip-over protection yes
Tubes 4
Dimensions: H/W/D 450 x 380 x 250 mm
Nett weight 2,7 kg
WARNING!
The heater surface can reach high temperatures. There is a danger of burns.
Handling with the device requires increased attention.
Do not use near highly flammable materials (eg. curtains, paper etc.)
EN