MACHINE STATUS MENU
* Value: to be compiled manually by user with any custom settings (if different from default settings)
** Level: indicates the visibility level of parameters accessed using a password (see relevant paragraph)
*** PA2 is visible at level 1 in the CnF folder whereas it can be modified at level 2 in the diS folder
RESPONSIBILITY AND RESIDUAL RISKS
Eliwell shall not be liable for any damages deriving from:
- installation/use other than that prescribed and, in particular, which does
not comply with the safety standards specified in the regulations and/or
those given herein;
- use on boards which do not guarantee proper protection against electric
shock, water or dust when assembled;
- use on boards which allow dangerous parts to be accessed without the
use of tools;
- tampering with and/or alteration of the product;
- installation/use on boards that do not comply with the standards and
regulations in force.
DISCLAIMER
This document is the exclusive property of Eliwell and cannot be repro-
duced and circulated unless expressly authorized by Eliwell.
Although Eliwell has taken all possible measures to guarantee the accuracy
of this document, it declines any responsibility for any damage arising out
of its use.
The same applies to any person or company involved in preparing and writ-
ing this document.
Eliwell reserves the right to make any changes or improvements without
prior notice and at any time.
EWDR 983-985/CS (LX) - EWDR 985/CSK (LX)
9/12
MENU nAd
if alarm(s)
present
AL
Pb1
Pb2
SEt
alarms
Pb1 value
Pb2 value
SEt value
set
change SEt
value
show alarms
if present
press and release
(single press)
Pb3
Pb3 value
if present
rtc
h00
d00
'00
2 sec
2 sec
set
hours
set
days
set
minutes
if present
d00= Sunday
d2
Ed
change value
E00…03
press and release
(single press)
d3
d1
E01
E00
E02
set
E01
set
E00
set
E02
nad
E03
set
E03
as above
as above
as above
day 1 = Sunday
day 2 = Monday
day 3 = Tuesday
Every Day = all days
FnC FUNCTION FOLDER
The FnC folder (last folder visible from the Programming Menu, level 1) contains
the following functions.
They are activated using the “set” button
If the unit is switched off, the function labels go back to their default status.
Function
Reduced set point
Aux
**default
Function label
NOT ACTIVE
SP**
AoF
Label
Function
ACTIVE
OSP
Aon
CONDITIONS OF USE - PERMITTED USE
For safety reasons the instrument must be installed and used in accor-
dance with the instructions supplied. Users must not be able to access
parts with dangerous voltage levels under normal operating conditions.
The device must be suitably protected from water and dust depending on
the specific application and only be accessible using special tools (except
for the front keypad).
The device is ideally suited for household use and/or similar use in the
refrigeration sector and has been tested with regard to safety in accor-
dance with the European harmonized reference standards. It is classified
as follows:
• as an automatic electronic control device to be independently mounted
as regards its construction;
• as a 1 B type operated control device as regards its automatic operating
features;
• as a Class A device as regards the category and structure of the soft-
ware.
UNPERMITTED USE
The use of the unit for applications other than those described above is
forbidden. It should be noted that the relay contacts supplied with the
device are functional and therefore exposed to potential faults. Any pro-
tection devices required to comply with product requirements or dictated
by common sense due to obvious safety reasons should be installed
externally.
