OPERATING INSTRUCTIONS
WET PICK-UP
This cleaner requires only a minimum of conversion when going from dry to wet pick-up. Remove disposa-
ble filter bag. The cartridge filter must be positioned over the filter cage while vacuuming liquids. When
picking up several tanks full of liquid, the cartridge filter will become saturated and misting may appear in
the exhaust air. At this time, you should dry or replace the cartridge filter to eliminate the misting and possi-
ble dripping of liquid around the lid. After completing a wet pick-up job, raise the hose to drain any excess
liquid into the tank before shutting off. The interior of the tank should be periodically cleaned.
1. Always disconnect the plug from the wall receptacle before removing the power head. Place power head
in an upside down position. Remove cartridge filter by sliding it up and off the filter cage.
2. Shake excess dust off cartridge filter with a rapid up and down movement.
NOTE:WET PICK-UP ACCESSORIES SHOULD BE WASHED PERIODICALLY, ESPECIALLY AFTER
PICKING UP WET,STICKY KITCHEN ACCIDENTS. THIS CAN BE ACCOMPLISHED WITH A WARM
SOLUTION OF SOAP AND WATER.
3. This wet/dry vac is equipped with a float mechanism which will rise automatically to cut off the airflow
when the liquid in the tank reaches a predetermined level. When this happens, turn off vac, unplug the
power cord, and empty the dust tank. You will know that the float has shut the airflow off because the
suction ceases and the motor noise becomes higher in pitch due to increased motor speed. The liquid
capacity may vary with the rate of pickup.
IMPORTANT: To reduce the risk of damage to the vac, do not run motor with float in raised position.
NOTE:IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD CLOSED SUCTION. IF THIS
OCCURS, PLACE VAC IN UPRIGHT POSITION AND TURN SWITCH OFF. THIS WILL ALLOW THE
FLOAT TO RETURN TO ITS NORMAL POSITION, AND YOU WILL BE ABLE TO CONTINUE OPERA-
TION.
8
www.ELITETOOLS.co
Keep Working
Содержание VC0850P
Страница 28: ......
