Pull-Out Pantry
Installation Instructions
for 400MM and 450mm width cupboards
Step Five – Door Alignment and Stabilisation
Horizontal Door Adjustment:
Loosen (but do not remove) the middle
Hex Bolt on Top and Bottom T-Bars (A) (see Step 4). Then use the left
and right Hex Bolts (B) to position the Door horizontally. When the
horizontal position is correct, tighten the middle Hex Bolts to fasten the
Door to the Frame
Vertical Door Adjustment:
Loosen (but do not remove) the Riser Anchor
Nuts (C) (see Step 3) on the Base Runner. Then use the M8*20
Adjustment Bolts (D) (see Step 3) to position the Door vertically. When
the vertical position is correct, tighten Riser Anchor Nuts (C).
Affix Saddle Backed Stabilisers:
(Note: You may wish to do this after
Step 6 so the position of the Stabilisers does not interfere with the pantry
baskets.) Affix the two Saddle Backed Stabilisers (E) over the Frame
front vertical bar to the Door to stabilise the Door using 4 x ST$*14
Countersunk Head Screws for each Stabiliser
Vertical Door Adjustment
2
Horizontal Door Adjustment
1
A
B
B
C
C
D
D
Affix Stabilisers
3
E
E