A
Front Edge
1
2
1.
Half insert 8x Leg Frame Bolts ‘G’ into each Leg Frame ‘B’
(16x in total) at position ‘Z’ leaving a 5mm gap for the Top Rail
to be inserted.
2.
If using a Double Bench with Shared Inset Leg, half insert
16x Shared Leg Frame Bolts ‘H’ into the Shared Inset Leg
Frame ‘C’ at position ‘Z’ leaving a 5mm gap for the Top Rail to
be inserted.
3
4
9
3.
Place the Top Rails ‘D’ on top of the half inserted Leg Frame
Bolts ‘G’ and fully tighten.
4.
At this point place the Double Bench Cable Tray ‘F’ between
the middle 2 Top Rails ‘D’.
This is not retro fittable and cannot be placed once the Desktop
is in place.
5
6
5.
Place Arms ‘E’ along the Top Rails ’D’ over the pre-drilled
holes and fix together using the Top Rail Bolts ‘J’.
6.
Place Desktop ‘A’ on a flat surface and attach 3x Sliders ‘L’
to the scalloped end of the Desktop using 3x Slider Screws ‘K’.
7.
With assistance, turn Desktop ‘A’ and place it over the Arms
‘D’ so the 3x Sliders ‘L’ align with the apertures within the Arms
‘E’.
B
B
8.
Push Desktop ‘A’ towards the centre of the assembled frame
and attach 3x Sliders ‘L’ near the front edge of Desktop using
3x Slider Screws ‘K’.
The Linnea Double Bench is now complete.
C
7
8
9.
If using a Double Bench Screen, attach Screen Bracket ‘M’
to the topside of Leg Frame ‘B’ using Screen Bracket Bolt ‘N’.
10.
Align Screen ‘Q’ to the Screen Brackets ‘M’ and connect
together so the Screen ‘P’ touches the Leg Frame ‘C’.
10
G
G
H
D
D
F
D
D
A
D
B
L
A
Front Edge
K&L
M
P
K&L
Scalloped Edge
