Rev. 11/13/2015 EA
www.elitescreens.com
Troubleshooting steps for the Elite Screens ZSP-TR01
Wireless 5-12V Trigger Remote
Make sure the Wireless 5-12v trigger is properly synced to your Elite Electric
Screen before proceeding to the troubleshooting steps.
1. Before connection to the projector, press the Up and Down buttons on the
wireless 12V remote to confirm Up/Down screen control.
2. Check that the positive (+) and negative (-) wires match the pins in the 3.5mm
jack.
(Reversing the polarity will work in some cases)
3. Use a 9V battery to power the screen via the RJ-45 port with the provided
12-volt trigger (green=ground, red=positive), and check if it will operate the
screen Up/Down. If the 9V battery operates the screen, this indicates that the
projector is not sending a signal to the 5-12V wireless remote.
4. If these provided steps do not resolve the issue, then the wireless 12V trigger
remote must be replaced.
