V022814-JA
www.elitescreens.com
4
Standard Accesories for Starling Tension Series
A. RF remote
B. IR remote
C. Extended IR
sensor
D. 5-12 volt
tirgger
Operation
Electric current
: The screen operates on AC110V at 60hz
Caution
: The screen’s motor is equipped with a thermal heat protector which will cause the motor
to stop running and prevent overheating if it is in continuous use for more than four minutes.
When this occurs, please allow the motor to cool down and use again after 15 minutes.
1. Plug the screen’s power cord to a power outlet.
2. Once the screen has power you’ll be able to control it with the Infared or Radio Frequency remote.
Control System
The
Starling Tension Series
has
Infrared
and
Radio Frequency
receivers. You can control the screen’s
UP/STOP/DOWN
positions utilizing either the IR (Infrared) or RF (Radio Frequency) remotes.
1.
IR remote control:
The IR remote control requires line-of-sight to the IR sensor. Make sure to point the
IR remote directly to the IR sensor located on the left side edge of the screen.
Note
: a. The IR remote has a range of 15 feet.
b. The IR sensor must not be covered or blocked.
2.
RF remote control
: The RF remote does not require line-of-sight and can be used up to 50ft.
Press the
Down
button to Drop the screen
Press the
Stop
button to Stop the screen
Press the
UP
button to Retract the screen
How to program your RF remote to your screen
How to deprogram the RF remote and delete the code
Press and hold the UP button
for more than 3 seconds.
Plug the screen’s power
cable into a power outlet.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
Press the UP button
The receiver will beep
three times to confirm
the programming.
RF remote is ready to be used.
Press and hold the UP button
for more than 3 seconds.
Plug the screen’s power
cable into a power outlet.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
Press the DOWN button
The receiver will
beep three times.
Code has been deleted and RF
remote is no longer operational
