Installation
Attention
: Prolonged storage of the Insta-DEM in its factory packaging
may result
in the material not being able
to lie flat once removed from its tube. An easy way to remedy this is to remove the material from the tube and
roll it up in a reverse manner for 5 minutes. This will flatten out the material and make it more pliable to work
with.
1.
Clean the magnetic surface location w h e r e the
I nsta-DEM Sc reen
will be installed.
2.
Measure and mark the top-right and bottom -right corner of the installation location.
3.
Attach the Insta-DEM Screen to the top-right and bottom-right corner of the magnetic surface location
as shown below.
4.
Carefully unroll the material and firmly attach the top and bottom until the Insta-DEM Screen is
completely attached to the magnetic surface.
071213-JA
www.elitescreens.com
2
Magnetic surface
Wall
Magnetic
Surface
