PRODUCT WHITE PAPER
http://www.elitescreens.com
11
Elite Screens Inc. |Elite Screens Europe GmbH| Elite Screens India |Elite Screens China Ltd.
Elite Screens Taiwan Corp |Elite Screens Japan |Elite Screens Australia
6. Wireless 5-12 volt trigger (Item F, Fig 5)
:
The RF remote control serves as a dual purpose,
independently as a handheld remote control, or
in conjunction with the Wireless 5-12 volt
trigger cable. The radio frequency technology
can be programmed to send a wireless signal to
synchronize its drop/rise with the projector’s
power cycle.
4.4 Hardware Parts List
A. M12 Dry-wall anchor x 4 or 6
B. Bolt x 2 or 3
C. Masonry Screw x 4 or 6
C. Extruded Hanging Bracket x 2 or 3
120” & above x 3 brackets
4.5 Installation Instructions
Wall Screws included with this product are complementary and may not be adequate for all mounting
surfaces. Consult with a professional installer or hardware store for proper mounting screws and anchors.
Please consult a professional installer. Elite Screens is not liable for any faulty installations.
DC 5-12V
out
The back of the projector
Wireless5-12V trigger cable
UP
Stop
Down
Fig 5
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1
: Connect one end of the 3.5 mm wireless 5-12 volt trigger cable to the RF remote.
Step 2
: Connect the other 3.5 mm end of the wireless 5-12 volt trigger cable to your projector
Step 3
: Make sure to unplug your screen from the power outlet
Step 4
: Hold the
UP
button on your RF remote
Step 5
: While holding the
UP
button, plug the screen back to the power outlet
Step 6
: Wait 5 seconds and then release the
UP
button
Step 7
: Your 5-12V wireless trigger should now be activated with your screen and ready to be used
and able to control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around
20-30 seconds for full off and on cycle each time)
