09252018-JA
www.eliteproav.com
5
Wall brackets
distance = A
Screen
Installing the support bar to the screen
1.
Slide the center
Connector (I)
located on the bottom frame to the middle. Then place the
Support Bar (G)
on
top of the frame and align both screw holes of the
connector
and
support bar
. Use the
Support Bar Screw (F)
to secure the bottom of the support bar. Once the screw has been fully inserted, attach the top part of the support
bar to the top part of the frame
Installation
1.
Locate your desired installation location with a stud
finder (recommended) and mark the drill-hole area of
where the
s
creen is to be installed using the wall brackets
2.
Drill a pilot hole with a 3/16 bit for the wood
screws included for top/bottom placement of the
wall brackets.
3.
Line up and level the two top/bottom wall brackets with
the pilot holes and screw them in using a Phillips screwdriver.
Note: Make sure distance A is over 5-10mm than the height of the
frame.
4.
Position the fixed frame screen onto the top wall brackets and push down
at the center of the bottom frame to secure the installation.
5.
Then secure the brackets using the
M6x10 Screw
(K) into the
connector
(I) on the top and bottom of the frame.
For a local Elite ProAV contact or Technical Support, please visit
www.eliteproav.com
Center support bar (E)
Plastic hole
Connector(I)
Screws for support bar (F)
