1
INSTALL FRONT MOLDING
B.
Insert Back Panel (H) into slots at back
inside edges of Side Panels B and C.
C.
Using 4
screws (L),
secure Back
Panel and 2
Side Panels.
2
INSERT BACK PANEL
H
H
L
C
C
E
E
B
B
D.
Add Plastic
Covers (T) to
each of the 4
screw locations.
H
T
C
E
B
*IMPORTANT: Make sure shelf pin holes on Side Panels
B & C face inside during assembly.
FRONT EDGES of Side Panels B & C do NOT have
holes. Curved Molding (Front Metal Molding - E) will be
inserted into Front Edge of Side Panels B & C with
metal tabs facing the back of unit.
BACK EDGES of Side Panels B & C DO have holes for
installation of Back Panel (H). Back Metal Posts (F) with
Pins (G) will be inserted into Top Back Edges of Side
Panels B & C.
Use a padded hammer or a regular hammer with a
block of wood when tapping molding into place.
Tap left and right sides of molding alternately to make
sure that molding is inserted evenly into both side
panels. Do not fully tap in one side of molding before
tapping in the opposite side. This may cause damage to
side panels.
Install Front
Molding (E) by
slotting peg
ends into holes
provided on
Right Side Panel
(C) and Left
Side Panel (B).
CORRECT
MOLDING IS PARALLEL WITH
EVEN INSERTION OF PEGS.
INCORRECT
UNEVEN INSERTION OF PEGS
MAY DAMAGE SIDE PANELS OR
BEND PEGS.
REGULAR HAMMER
WITH BLOCK OF WOOD.
PADDED HAMMER
E
B
C
Front Edges of Panels
C & B do not have any holes.
FRONT
Metal Tabs of Front
(Curved) Molding “E”
face the back of
the unit.
Tap right and left
sides of molding
alternately to
insure even
insertion of pegs.
C
B
E
A.
Remove protective foil from both
sides of Back Panel (H).
