Elite Fitness Trimline 1000, Инструкция по сборке, Страница: 12 / 21

12
Other
• The system will beep and enter into Manual mode once the countdown ends.
• The parameter function is in a Cycle mode. e.g.: The range of time is in between 5:00 – 99:00
When it is set in 99:00, it can directly revert to 5:00 by continuously pressing “+” buttons.
• You may only choose one type of countdown section (time, calorie, distance) for every cycle.
• Speed rectify range is 0.1km/h.
Troubleshooting
Problem
Reason Problem Solving
--------- Safety Key removed 1. Replace Safety Key.
2. Computer defective. Call an authorized service technician
to renew the safety key on/off switch or magnet inductor.
E01 Communication failure
for controller and
computer
1. Data cable or integrated circuit is loose or in improper
order. Try to reconnect or reorder.
2. Call an authorized service technician:
• Defective data cable
• Defective controller
• Defective transformer
E02 Speed control sensor or
motor fault
1. Check if the power voltage is 50% lower than the
standard voltage. Please make sure the power and voltage is
complying with standard.
2. Check if the motor wire is well connects. Reconnect the
wire and restart. Call an authorized service technician if this
problem persists.
3. Check if the controller has a smoky smell, the IGBT could
be in short circuit. Contact an authorized service technician
for maintenance.
E04 Incline sensor or motor
fault
1. Check if the incline motor signal cables and AC wires are
firmly connected.
2. Call an authorized service technician:
• Damage to incline motor or AC motor signal cables
• Defective motor controller
E05 Overcurrent protection 1. Overload current will stop the device from operating.
Simply restart the machine to solve this problem.
2. Jammed or defective components will cause an overload
in current. Apply lubricant to the specific area and restart
the device.
3. Check if there is a smoky smell or sound that is caused by
the motor or controller. Call an authorized service technician
for maintenance.
No
Display
Machine breakdown
or power supply is
disconnected
1. Check if the overcurrent protection switch is on or off.
2. Check the power switch, overcurrent protection, display
cables, transformer and motor are connected and in
good condition.
3. Call an authorized service technician for maintenance
USER INSTRUCTIONS