Troubleshooting
Should an error occur, first check the following points:
Having this problem?
Check the following points:
No Flash unit is triggered by the
Transmitter
Mode “
All
” is selected
Ø
Check if the Transmitter is switched ON
Ø
Check battery polarity
Ø
Check if the Receiver module is connected correctly to the unit
Ø
Check if the frequency selector switch is set to the same
channel
Some Flash units are not trig-
gered by the Transmitter
Mode “
Grp
” is selected
Ø
Check if the Channel selector switch is set to the same Group
Ø
Reduce distance to any “not working” units
TEST flash works, but the camera
will not trigger Flash unit
Ø
Check hot-shoe fitting
Ø
Choose SYNC cable instead of hot-shoe connection
Distance range is too small
Ø
Reposition the unit
Ø
Increase the distance to walls and ceilings
Ø
Position the antenna of Transmitter and Receiver
Ø
Use an RX extension cable to reduce the distance between
modules
CE Statements
This device has been tested and found to comply with the requirements set
up in the council directive on the approximation of the law of member states
relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and
R&TTE Directive 99/5/EC
EL-Skyport Modules
EL-Skyport Universal 19352
• Universal Receiver for all makes of Flash having a SYNC socket!
EL-Skyport Transceiver RX 19353
• This Transceiver is only for Elinchrom RX units. The module operates all RX
features with the EL-Skyport / ERS- software and triggers the flash
EL-Skyport USB RX 19354
• To operate RX flash units via computer the USB module should be used in
conjunction with the EL-Skyport Transceivers RX and the ERS- software
Universal
19352
Transceiver RX
19353
USB RX
19354
6
7