ELICA Nuage Sense, Инструкция по монтажу и эксплуатации

Страница: 21 / 108

21
Attention! Before connecting the hood to the electrical
mains.
If you have an Elica hob:
Perform the electrical connections of the hood and Elica
hob
at the same time to ensure the logical connection
between the hob and Elica hob (also refer to the
paragraph "
Operation-Adjusting the parameters for
automatic operation-Sensor calibration " e " Operation-
Adjusting the parameters for automatic operation-
Logical connection between hood and Elica hob
").
If you do NOT have an Elica hob:
In this case, after being connected to the mains, the hood
will try connecting to a hob.
Wait for the hob to complete the connection attempts
(approximately 5 minutes) and then disable the electronic
connection module as follows:
With the hob switched off, simultaneously press and hold
keys
T1 and T2 for 10 seconds, (see Operation
paragraph), the hood at first emits a short sound signal
(beep- after approximately 5 seconds), followed by a long
sound signal (beeeep), indicating that the disabling
process is complete (LED
L1 turns red for a few
seconds).
Reactivating the connection module between the
hood and Elica hob:
With the hob switched off,
simultaneously press and hold keys T1 and T2 for 10
seconds, (see Operation paragraph), the hood at first
emits a short sound signal (beep- after approximately 5
seconds), followed by a long sound signal (beeeep),
indicating that the activation process is complete (LED
L1
turns red for a few seconds).
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.