ELICA ISMART EFL HAC LTW 60, Инструкция по монтажу и эксплуатации

Страница: 4 / 8

4
Operation
Touch Control:
F1 – ON / OFF (Stand-by)
Allows to turn on the lights on the control panel and the cooker
hood is now in stand-by mode. Touch the button one more
time to turn off.
F2 – ON / OFF Lights
Allows to turn on and off the lights
F3 – Engine Speed Increase
Enables the startup of the engine and the speed increase , from 1
to 24.
F4 – Engine Speed Decrease / OFF
Decrease the speed of the engine, until it shuts off.
D – Display
Allows the viewing of:
−
Motor speed status
− HAC function
−
Child lock function
−
Timer function
Motion Sensor:
Motion Sensor is the ability to recognize and interpret movements
of the human body in order to interact with and control a PCB
system without direct physical contact.
Put your hand up in front of the glass having sensor area (S),
reasonable distance is up to 50 mm from glass front, then start to
control cooker hood by hand wave.
−
From left to right: the cooker hood will start operating on 4th
speed with lamp turn ON. Further movement will increase the
speed of cooker hood with multiplication of 4 speed.
−
From right to left: the cooker hood speed will decrease in
multiplication of 4 speed and further movement will turn off the
cooker hood.
Heat Auto Clean (HAC) Function:
A unique “Heat Auto clean” function has been provided in the
cooker hood.
This cooker hood comes equipped with oil collector tray. During
cooking, excess oil and dirt which get sucked in to the cooker hood
gets drained into this oil collector.
However, over the time, some traces of stubborn greases and oil
can get stuck inside the cooker hood.
To eliminate these and clean the cooker hood from inside:
−
Make sure that the cooker hood is in stand-by mode. Now press
& hold F1 button. A reserve timer of 9 minutes will get activated
and the light for HAC will start blinking.
−
After a special heater has worked for 9 minutes, the fan will
automatically start operating at low speed for 1 minutes.
−
Most of the grease present within the cooker hood will get
evaporated and blown out of the air outlet. Any remaining
grease will get drained out into the oil collector tray located at
bottom of the hood.
−
The Heat auto clean function will stop operating at the end of
10 minutes.
− Wait for the moment and then carefully remove the oil collector
tray (Fig.8) ensuring that you do not spill the grease.
−
Drain the collected grease into the sink and clean the oil
collector tray with soft cloth.
−
Fix the oil collector tray back at the place by sliding it in the rails
at the both ends. Ensure that tray is fixed properly (Fig.8) .
Child Lock:
To lock motion sensor, press and hold the F2 button when cooker
hood is in OFF position. Display (D) will show “OFF”. To turn on
motion sensor, again press and hold the F2 button. Display (D) will
show “ON”.
Timer function:
When cooker hood is running on any speed, press the F1 button.
Display (D) will show countdown and cooker hood will turn OFF
after completion of 3 min timer.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid detergent.
DO NOT CLEAN WITH TOOLS OR INSTRUMENTS . Do not use
abrasive products. DO NOT USE ALCOHOL !
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
To replace lights, contact authorised spare part center.