ELGO Electronic P40-000 Series, Руководство по эксплуатации

Страница: 15 / 64

Handling & Operating Modes
- 15 -
7 Handling & Operating Modes
7.1 Operating Modes
Depending on the parameter setting, the screen display and assignment of the function keys can vary.
7.1.1 Manual Operation
In this mode the axes can be moved manually (manual inching). To do this, select the corresponding axis with
the cursor and change the position by using the functional keys F1 / F3.
Figure 5: Manual Operation
Displays the actual position of the respective axis
Moves the axis in negative direction
Moves the axis in positive direction
Referencing of the respective axis: Use the cursor to select the
desired axis and press the F2 button longer than 2 seconds.
Note!
The parameter axis

times (

9.2)

“manual change” can be used to define a time. In
case of manual operation, there is a change from creep speed to fast speed after the expi-
ration of the time adjusted here.
See also table in section

14.2 parameter axis

times

“manual change”
Referencing:
see chapters:

7.2 “Referencing an Axis”,

9.3 “Parameter Axis: “
and table in section

14.1 “Parameter Axis: Distances”
3 4 2
1
1
2
F1
3
F3
4
F2