15
7.3
Sticking and Cutting
Note!
When gluing / sticking the magnetic tape pay attention to the marks on the magnetic
tape. Improper installation delivers in correct values. A previously glued tape is destroyed
after removal and cannot be reused. Before the start of the bonding are magnetic tape
and masking tape to the exact length basis. Observe also the counting direction of the
measuring system. Before adjusting the tape (gluing) please cut the magnetic tape and the
cover band to exact the length.
Length of magnetic tape = Measuring Sensor length
Preferably, the magnetic tape should be stuck into a nut or aligned to an edge.
Procedure for sticking:
1.
The magnetic tape is already factory bonded with the steel band, in between is a double sided sticky
tape. Stick the provided sticky tape onto the carrier side (=steel band)
2.
Now adjust the magnetic tape and stick it onto the surface. The best way to stick the magnetic tape
is to do it in two steps. Remove the first half of the adhesive film from the sticky tape and adjust it
then do the rest length.
3.
Then stick the sticky tape onto the covering band. It is not important on which side of the covering
band the sticky tape is stuck on.
4.
Stick the covering band onto the visible brown magnetic tape.
Options
